On page-2 of the users manual for the HS3 it shows the pin outs for the HS3 and the target device. If the views shown are the bottom and when mating, the signals will be reversed. What pin outs do I use for my target PCB? Also is there a recommended 14-pin 2.0mm shrouded connector (mfg and part number)? Thanks, Mike Handy
Question
mike123456789
On page-2 of the users manual for the HS3 it shows the pin outs for the HS3 and the target device. If the views shown are the bottom and when mating, the signals will be reversed. What pin outs do I use for my target PCB? Also is there a recommended 14-pin 2.0mm shrouded connector (mfg and part number)?
Thanks,
Mike Handy
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.