tekson Posted April 9, 2018 Share Posted April 9, 2018 Hi all, How to implent delay in verilog code? I want to run a led blink code with one second delay using zynq zybo-7-z10 Thanks in advance Link to comment Share on other sites More sharing options...
D@n Posted April 9, 2018 Share Posted April 9, 2018 Have you seen this article? It goes about describing this Verilog delay code (here). The code is really written for signal processing, not so much LED blinking. Were you to use it, you'd probably want to slow down the LED sample rate, lest you use all of your block RAM describing a sample-by-sample delay. How exactly you'd do this depends upon your signal source. One option might be a 1-bit block averager, but like I say this all depends upon your source. Dan Link to comment Share on other sites More sharing options...
Question
tekson
Hi all,
How to implent delay in verilog code?
I want to run a led blink code with one second delay using zynq zybo-7-z10
Thanks in advance
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.