Hi there, new to teh forums. Thanx in advance for any help.
So bought the Chipkit WF32 / Labview bundle. Downloaded Labview. Loaded Ni_Visa drivers. Did the LINX thing. All good.
Opened the Blink (Simple) example and ran it. It looks as though it is all connecting. LED6 flashes a few times and then the two red leds are on and flickering and the panel says that it is looping at 200Hz. But nothing happens when I click the big green button.
The example says that output 13 is the on-board led that should be turning on and off.
Do I need to do any configuration on teh Chipkit WF32, or should it just work?
Question
austbots
Hi there, new to teh forums. Thanx in advance for any help.
So bought the Chipkit WF32 / Labview bundle. Downloaded Labview. Loaded Ni_Visa drivers. Did the LINX thing. All good.
Opened the Blink (Simple) example and ran it. It looks as though it is all connecting. LED6 flashes a few times and then the two red leds are on and flickering and the panel says that it is looping at 200Hz. But nothing happens when I click the big green button.
The example says that output 13 is the on-board led that should be turning on and off.
Do I need to do any configuration on teh Chipkit WF32, or should it just work?
Thanx again.
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.