Jonathan Tran Posted August 27, 2015 Share Posted August 27, 2015 Hello, I have a Basys2 FPGA Board. What is the default frequence oscillator if I do not select the position of the jumper (JP4). Thanks, Jonathan Tran Link to comment Share on other sites More sharing options...
Commanderfranz Posted August 27, 2015 Share Posted August 27, 2015 Hi Jonathan, The default frequency is 50 MHz. If you go to the schematic page six, you will find this note. If you go to the Oscillators section of the Basys 2 reference manual, as shown below, there is a diagram for each jumper configuration. Kaitlyn Link to comment Share on other sites More sharing options...
Jonathan Tran Posted August 27, 2015 Author Share Posted August 27, 2015 Hello Kaitlyn, Thanks so much , Jonarthan Tran Link to comment Share on other sites More sharing options...
Question
Jonathan Tran
Hello,
I have a Basys2 FPGA Board. What is the default frequence oscillator if I do not select the position of the jumper (JP4).
Thanks,
Jonathan Tran
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.