I just received my AD2, and I really like it! I like the WG and the scope, and while it took me a little while to figure out the Protocol analyzer, it does a pretty good job showing the data.
However, at first glance, the SPI protocol handler under the logic analyzer is somewhat limited because it only handles one channel. One could capture four signals by using the logic analyzer and doing the work manually, but I would like to be able to handle all four (or 6) SPI channels in the logic analyzer, too. I have an MCP3208 which requires a command in the first 10 bits, and then in the next 14 bits returns the data on the MISO pin.
Is there any way to do this in the logic analyzer?
Question
mgssnr
Hello,
I just received my AD2, and I really like it! I like the WG and the scope, and while it took me a little while to figure out the Protocol analyzer, it does a pretty good job showing the data.
However, at first glance, the SPI protocol handler under the logic analyzer is somewhat limited because it only handles one channel. One could capture four signals by using the logic analyzer and doing the work manually, but I would like to be able to handle all four (or 6) SPI channels in the logic analyzer, too. I have an MCP3208 which requires a command in the first 10 bits, and then in the next 14 bits returns the data on the MISO pin.
Is there any way to do this in the logic analyzer?
Thanks
Matt Gessner
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.