rsip 0 Posted February 19, 2018 Hi, I need the .iic file in order to upload the eeprom IC5, where the Cypress CY7C68013A firmware is stored, by means of CyConsole tool. Currently IC5 does not assert the USB-ON signal, which enables the power on the board. Sincerely, Radek (rsip) Share this post Link to post Share on other sites
0 jpeyron 657 Posted February 19, 2018 Hi @rsip, I am tagging the engineer that handles EEPROM issues( @Bianca). thank you, Jon Share this post Link to post Share on other sites
0 BogdanVanca 43 Posted February 22, 2018 Hello @rsip, Please try the solution attached to this message. Best Regards, Bogdan Vanca DigilentFX2Repair.rar Share this post Link to post Share on other sites
0 rsip 0 Posted February 22, 2018 Thanks Jon for redirecting and hi Bogdan, I've installed your software before connecting Nexys2 by USB cable and then plug it. I got the following message: Device 0 \\?\usb#vid_04b4&pid_8613#5&30d2dfde&0&1#{ae18aa60-7f6a-11d4-97dd-00010229b959} Header: 00 47 05 31 21 00 00 04 00 04 00 00 02 2A A3 32 Data: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF CD AB 44 4F 6E 62 55 73 62 00 14 B3 4F 6E 62 55 73 62 EB FF FF FF FF FF FF FF FF FF FF FF FF FF 78 56 31 30 30 35 34 44 31 32 33 34 35 36 BF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF Device Name: "" User Name: "DOnbUsb" After that I've installed .iic for Nexys2 and got information about new device working in the system (Device type: Programming cables -> Xilnix USB Cable). Newertheless I still don't have the USB power on the board except the CY7C68013A. I had hope earlier that new firmware will cause that the USB-ON signal driven from PD7 pin will be asserted, but is not. Could you explain this? Share this post Link to post Share on other sites
0 radoslaw 0 Posted March 6, 2018 The problem has been resolved. See the following topic on this forum. Thanks Share this post Link to post Share on other sites
Hi, I need the .iic file in order to upload the eeprom IC5, where the Cypress CY7C68013A firmware is stored, by means of CyConsole tool. Currently IC5 does not assert the USB-ON signal, which enables the power on the board. Sincerely, Radek (rsip)
Share this post
Link to post
Share on other sites