i am using cmod a7 and for programing i am using vivado15.1 .
when trying to program device or to connect to device it shows:
No hardware targets exist on the server [localhost:3121]
Check to make sure the cable targets connected to this machine are properly connected
and powered up, then use the disconnect_hw_server and connect_hw_server commands
to re-register the hardware targets.
i have to restart my computer and then it works fine.but after programing and implementing once the error occurs again.any advice will be helpful .
Question
anurag
hello
i am using cmod a7 and for programing i am using vivado15.1 .
when trying to program device or to connect to device it shows:
No hardware targets exist on the server [localhost:3121]
Check to make sure the cable targets connected to this machine are properly connected
and powered up, then use the disconnect_hw_server and connect_hw_server commands
to re-register the hardware targets.
i have to restart my computer and then it works fine.but after programing and implementing once the error occurs again.any advice will be helpful .
thanks
Link to comment
Share on other sites
8 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.