Waveforms Manual Does not have a section for the Protocol tab

[Dave S.]

Can someone please point me to a manual for the Protocol section of the Waveforms software?

I would like to send an I2C command over a bus but I am getting an  I2C bus error. Verify the signal pull-ups error.   I do have the appropriate pullup resistor however.

Also, it's not clear how the interface works.  A manual would be useful.

 

Thanks,

Dave

 

[JColvin]

Hello @Dave S.,

I have moved your question to a more appropriate section of the Forum. There is also a tutorial on the Protocol Analyzer here as well as some built in documentation available in WaveForms itself under Help>Browse, and then under Protocol on the left hand side on the web page that is brought up.

Let me know if you have any other questions.

Thanks,
JColvin

[attila]

Hi @Dave S.

The Protocol interface uses the Pattern and Logic Analyzer device resource.
Make sure to not to drive digital IOs from Static IO interface since the IOs are multiplexed in the device and Static IO has higher priority than Patterns. 

The latest reference manual, corresponding to the software version is included in the application.
See the Help tab in the WaveForms application or Help/Browse menu.