I was earlier able to flash LEDs on the Zybo 7010 board following the tutorials. However, I am currently trying to use the Zybo 7010 to flash LEDs which are external to the board. What I am looking at here is getting a constant voltage supply from one of the ports (maybe preferably the Xadc) to power the external LED circuit. I am having trouble getting a block design using the xadc_wiz_0 ip and the axi gpio with the zynq 7000 processor. Any information on this is greatly appreciated.
Question
Allan
Hello,
I was earlier able to flash LEDs on the Zybo 7010 board following the tutorials. However, I am currently trying to use the Zybo 7010 to flash LEDs which are external to the board. What I am looking at here is getting a constant voltage supply from one of the ports (maybe preferably the Xadc) to power the external LED circuit. I am having trouble getting a block design using the xadc_wiz_0 ip and the axi gpio with the zynq 7000 processor. Any information on this is greatly appreciated.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.