Jump to content
  • 0

Modifying the HDMI out of ATLYS HDMI DEMO SPARTAN 6


M.Saad Ikram

Question

Hi, I implemented the demo project ATLYS HDMI given in the resources of spartan 6.... But my project is to perform thresholding on the coming RGB video from the input source... and then show it to the output..... What I have been able to gather from the DEMO project is that the data is stored in the buffer register from the incoming input video source but I want to modify the data... and show an RGB to YUV converted video......... Kindly guide me.......... I specially request Jpeyron to look over

Link to comment
Share on other sites

6 answers to this question

Recommended Posts

Are you needing to operate on the video stream at the same rate it is coming in (lets say framerate of ~60Hz), or is it ok to operate on the frame at a slower rate (Lets say ~0.1Hz framerate).

This is important because your needs indicate whether you should do the detection in microblaze software (easier, but slower) or in the HDL (harder, but faster).

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...