Jump to content
  • 0

Digilent "Genesys" w/ Virtex 5 FPGA Dev board


jlmoon

Question

Greetings,

 

New user to the forum, hope I can contribute some in the not so distant future. 

 

I am here by the recommendation of Digilent technical support. 

I am the new owner of a suspected malfunctioning Dev board (Genesys / Xilinx ) .  Perhaps someone out there has some on hands experience with this particular product?  I am having difficulty getting a power good indication (LD8) when I apply the required 5V supply.  For a short time I have been exploring the Adept interface in an attempt to communicate with the board and when using the Power meter I notice the various voltages along with respected currents seem to be okay except the 2.5 V output indicates around 2 Volts and shows around -8 to -10 mA current.  To me, this suggest no 2.5 V supply being generated by the switch mode power supply, are there any suggestions what to look for?  So far, I have not had much success with email support in this matter.  I really would like to get upto speed so I can contribute to the FPGA development community.

 

 

Thank you in advance,

 

J.L. Moon

 

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...