I want to understand the main difference when programming a board which is configured using a BSP (Ex: ZYBO) and which is configured using only device details(Ex: xc7z010clg400-1). I'm asking because I'm configuring only zynq in the block design with uart1 for hello world application. If I program using ZYBO bsp it works but not if I use only the device details. I need to understand this since my actual project is on a custom z7010 board and not a regular development board and I'm not able to get the uart up and running. I wanted to figure it out on a development board as it is easier to understand.
I think it is some simple settings detail that I'm missing. Appreciate any help.
Question
Axe
Hi,
I want to understand the main difference when programming a board which is configured using a BSP (Ex: ZYBO) and which is configured using only device details(Ex: xc7z010clg400-1). I'm asking because I'm configuring only zynq in the block design with uart1 for hello world application. If I program using ZYBO bsp it works but not if I use only the device details. I need to understand this since my actual project is on a custom z7010 board and not a regular development board and I'm not able to get the uart up and running. I wanted to figure it out on a development board as it is easier to understand.
I think it is some simple settings detail that I'm missing. Appreciate any help.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.