I am trying to use the Pmod ACL with my PYNQ board, but i am not able to read any data from it. I was able to use it with my ZYBO board, but using the same code with the PYNQ doesn't cut it. Is it possible that some Pmods aren't compatible with the PYNQ? I haven't been able to find much documentation on the pinnout for the pmod ports either... any suggestions?
Question
dzlot
I am trying to use the Pmod ACL with my PYNQ board, but i am not able to read any data from it. I was able to use it with my ZYBO board, but using the same code with the PYNQ doesn't cut it. Is it possible that some Pmods aren't compatible with the PYNQ? I haven't been able to find much documentation on the pinnout for the pmod ports either... any suggestions?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.