Alfredo Posted November 30, 2017 Share Posted November 30, 2017 Hi, I've purchased a Multi-Touch Display Shield, load libraries, example sketches on my Arduino IDE, compiled without errors all MyDisp examples, but: display is switched on but black serial port post "myDisp.begin failed" I tried on a Leonardo and a Mega. Can you help me? Link to comment Share on other sites More sharing options...
Alfredo Posted November 30, 2017 Author Share Posted November 30, 2017 I have resolved putting CS pin at ground, with this code: pinMode(10, OUTPUT); digitalWrite(10, LOW); Bye Link to comment Share on other sites More sharing options...
jpeyron Posted November 30, 2017 Share Posted November 30, 2017 Hi @Alfredo, So by putting the CS pin at ground did that resolve the myDisp.begin failed? thank you, Jon Link to comment Share on other sites More sharing options...
Alfredo Posted December 1, 2017 Author Share Posted December 1, 2017 16 hours ago, jpeyron said: Hi @Alfredo, So by putting the CS pin at ground did that resolve the myDisp.begin failed? thank you, Jon Yes, bye Link to comment Share on other sites More sharing options...
Question
Alfredo
Hi,
I've purchased a Multi-Touch Display Shield, load libraries, example sketches on my Arduino IDE, compiled without errors all MyDisp examples, but:
I tried on a Leonardo and a Mega.
Can you help me?
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.