Pro MX7 NRST Stuck

[pappastech]

UPDATE: I figured out that I was just using the deprecated 'Ethernet' library instead of the DEIPcK library. It appears to be working now.

Thanks.

I just bought a Pro MX7 and pulled up an example Ethernet sketch, programmed the board but I get a "Failed to configure Ethernet using DHCP" message on the console. I checked the voltage on the NRST pin and it measures 0.45V. I'm not sure what exactly is wrong, but at the moment I'm suspecting a faulty PIC32 IC as I inserted 3.3V onto the NRST pin of the PHY directly and it lit up (LEDs on the RJ45 jack turned on). How do I go about getting this replaced?

I'm running Arduino v1.8.5 with a freshly downloaded (yesterday) version 1.4.3 of the Chipkit libraries to be able to use this board.

Thanks.

[JColvin]

Hi @pappastech,

Just to confirm, updating to the DEIPcK library fixed the NRST pin issue you were encountering?

Thanks,
JColvin

[pappastech]

2 hours ago, JColvin said:

Hi @pappastech,

Just to confirm, updating to the DEIPcK library fixed the NRST pin issue you were encountering?

Thanks,
JColvin

That's correct.

Thanks for the follow up.