Jump to content
  • 0

Connecting IP+ and IP- terminals of pmod ISNS20


suggi

Question

Hi

I'm planning to use the pmod ISNS20 for a project. I want to interface it with nexys4ddr board. The pmod isns20 has 2 interfaces: input : hall effect sensor's input terminals IP+ and IP-; output: ADC's output terminals: SDO; I'm familiar with the usage of the output interface with the nexys4 ddr using the SPI protocol. However, I'm not familiar with the input interface. I want to know if a sense resistor has to be used across the IP+ and IP- terminals? If so, what would be the equation of current? If no sense resistor is used, how to connect the terminals IP+ and IP- to the circuit? And again what is the equation of current being measured? 

I have seen the datasheets for both adc and hall effect sensor. Did not find any info on how to connect the IP+ and IP- terminals. Any help on this is highly appreciated.

 

Thanks

Link to comment
Share on other sites

2 answers to this question

Recommended Posts

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...