Jump to content
  • 0

Digilent Breadboard Adapter for AD2


Jon Frey

Question

The breadboard adapter would be convenient for some applications I have ,if the vertical connector for jumper wires was not present.Hardwired connections could be soldered to the through hole permanent breadboard area.

1) Can the board be purchased unpopulated, no connectors installed, no solderless breadboard ?

2) Would the board PCB files , less the artwork with the Digilent trademark, be available ? That would provide an easy start point to design custom interfaces , rather than start a board design from scratch.

Link to comment
Share on other sites

1 answer to this question

Recommended Posts

Hi @Jon Frey,

The BreadBoard adapter has no version of coming unpopulated. You can remove that connector, or leave it be and you can make hardwired connections on the bottom. The package comes with the solderless breadboard unattached to the board so that would be an extra for you and it's not necessary to use, unless you want to.

Regarding the PCB files, unfortunately, we don't release release them.

Best regards,

Bianca Peterlin

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...