Ethernet shield

[Monics 0]

I am looking at using the Digilent modules together with Labview LINX (Makerhub), and I need a setup with ethernet connection to Labview/LINX.

Digilent have retired the 410-211, Network Shield... but will I be able to use the Pmod NIC100 (together with max32 or uC32) and get support for ethernet interface through LINX....?

Br,
Martin Christiansen.

Edited October 5, 2017 by Monics

[jpeyron 566]

Hi @Monics,

I have moved you thread to a section that LabVIEW experienced engineers more commonly look. 

cheers,

Jon

[AustinStanton 8]

I am a little confused about your question. Are you trying to use the NIC100 to allow your board to communicate with LINX over ethernet instead of serial or are you trying to use LINX to allow you to communicate with something else over ethernet? 

Thanks 

Austin

[Monics 0]

Hi Austin...

OK, I will desribe what I intend to do.

I want a board which support ethernet access, fx like the digilent max32 board including the network shield. But, the network board is retired.... so what can I use instead?

Fx. Could I use the NIC100 with a digilent board to communicate with LINX over Ethernet?

Any experience would be nice to hear about.

br,

Martin C.

 

[AustinStanton 8]

That's technically possible but you would have to modify the ethernet listener in the firmware, this might be difficult if you don't have experience with this sort of thing. Why do you need to communicate over ethernet instead of UART?

 

[Monics 0]

AustinStanton

I find the speed of the serial interface to slow, 9600 baud.

The Ethernet should support much higher speed and respons.

Is there any other Ethernet boards for Arduino like boards, than the Digilent?

 

[AustinStanton 8]

What exactly are you trying to do? Have you looked into boards like the Beaglebone Black or Raspberry Pi? Also, I found the Network Shields in stock on this site.

[Monics 0]

I have looked at the RPi and BBB... but, as I understand, the LINX ver3 limits the use to non-commercial usage. I have a setup that is for commercial use.

Thanks for pointing to accessable network shield.