Mating Socket for CMOD A7-35T

[Brian Dubis]

I want to socket a CMOD A7-35T onto a test back plane.  What is the recommended "connector" to use to plug the two rows of 24 pins each, 0.1 inch pitch pins of the CMOD A7-35T into?  Prefer a thru hole part(s) for structural integrity in case there is a large insertion/removal force.  Maybe two rows of Samtec header receptacles. If someone knows the part number of the row of pins on the CMOD AT-35T then that would be helpful.  Thanks.

[jpeyron]

Hi @Brian Dubis,

I am doing research to get you more information. I know the Cmod A7 will fit any standard bread board and it is a 1x24,2.54mm(0.1"),Squarepin,Male,Straight.

thank you,

Jon

[dfergenson]

I just checked my Cmod A7 mating to two Sullins Connector PPPC062LFBN-RC (DigiKey p/n S7109-ND) and they fit. Because each connector is independent of the other, you'd have to solder the connectors into a PCB with the Cmod connected to make sure that they don't rock out of alignment with each other.