I just installed vivado 2017.2 on my PC, running windows 7 Service Pack1 (64-bit). I connected my Nexys 4 board using the cable that comes with the board in the package. When I attempted to connect the board to my PC, by clicking Open Hardware Manager -> Open Target -> Auto Connect, in the Hardware window in vivado, it shows localhost(0), which means no device detected. I also get 2 warnings below:
warning: cannot open library dpcomm.dll, first required symbol ftdimgr_lock, Digilent FTDI based JTAG cables cannot be supported
warning: cannot open library djtg.dll, first required symbol DjtgGetPortCount, select Digilent JTAG cables cannot be supported
I noticed a post in a non-English Digilent forum, in which someone else was experiencing the exact same issue. Please help.
Question
yyuan
Hi,
I just installed vivado 2017.2 on my PC, running windows 7 Service Pack1 (64-bit). I connected my Nexys 4 board using the cable that comes with the board in the package. When I attempted to connect the board to my PC, by clicking Open Hardware Manager -> Open Target -> Auto Connect, in the Hardware window in vivado, it shows localhost(0), which means no device detected. I also get 2 warnings below:
warning: cannot open library dpcomm.dll, first required symbol ftdimgr_lock, Digilent FTDI based JTAG cables cannot be supported
warning: cannot open library djtg.dll, first required symbol DjtgGetPortCount, select Digilent JTAG cables cannot be supported
I noticed a post in a non-English Digilent forum, in which someone else was experiencing the exact same issue. Please help.
yy
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.