Enumeration of the devices seems ok:
"djtgcfg enum" command finds two devices
initialisation of the jtag chain: Find an unknown target:
[root@nod092 digilent]# djtgcfg init -d Dps2
Initializing scan chain...
Found Device ID: 04b3109
Found 1 device(s):
Device 0: UNKNOWN
-Target programming: Failed:
[root@nod092 digilent]# djtgcfg prog -d Dps2 --index 0 --file ./top_ffff1.3.bit
Programming device. Do not touch your board. This may take a few minutes...
ERROR: failed to program device with file ./top_acf1.3.bit
Question
nicolas
Hello,
Has anyone had issues with using Digilents tools(Adept2: djtgcfg) to program .bit files on Xilinx ultrascale+ target ?
Here is our setup:
-Linux Centos 7
-digilent.adept.runtime-2.16.6.x86_64.rpm + digilent.adept.utilities-2.2.1.x86_64.rpm
-Hardware: Intel proc --> (USB )--> Digilent FT232H ---> (JTAG) ----> Xilinx Ultrascale+
Enumeration of the devices seems ok:
"djtgcfg enum" command finds two devices
initialisation of the jtag chain: Find an unknown target:
[root@nod092 digilent]# djtgcfg init -d Dps2
Initializing scan chain...
Found Device ID: 04b3109
Found 1 device(s):
Device 0: UNKNOWN
-Target programming: Failed:
[root@nod092 digilent]# djtgcfg prog -d Dps2 --index 0 --file ./top_ffff1.3.bit
Programming device. Do not touch your board. This may take a few minutes...
ERROR: failed to program device with file ./top_acf1.3.bit
Does Adept support Ultrascale+ target ?
Thanks in advance.
Regards,
Nicolas.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.