The first time I went through the tutorial at https://reference.digilentinc.com/learn/programmable-logic/tutorials/pmod-ips/start to instantiate the Pmod_ad1 IP, it worked fine. But I went back into the block diagram and tried to validate the design and I got the error "[BD 5-336] This command cannot be run, as the BD-design is locked...." (see uploaded image). Show IP Status says I need to upgrade parent IP. I downloaded the vivado-library-master.zip recently and I am running Vivado 2016.4 and targeting the Nexys 4 DDR board. I had to delete the part and re-instantiate it to get rid of error.
I'm also getting a critical warning [Common 17-69] Command failed: BOARD_PART_PIN cannot be assigned to more than one port [design_1_PmodAD1_0_0_board.xdc:7]
Is there a Nexys 4 DDR/Vivado 2016.4 specific library I need? Or is there an easy way to upgrade the IP?
Question
riche
The first time I went through the tutorial at https://reference.digilentinc.com/learn/programmable-logic/tutorials/pmod-ips/start to instantiate the Pmod_ad1 IP, it worked fine. But I went back into the block diagram and tried to validate the design and I got the error "[BD 5-336] This command cannot be run, as the BD-design is locked...." (see uploaded image). Show IP Status says I need to upgrade parent IP. I downloaded the vivado-library-master.zip recently and I am running Vivado 2016.4 and targeting the Nexys 4 DDR board. I had to delete the part and re-instantiate it to get rid of error.
I'm also getting a critical warning [Common 17-69] Command failed: BOARD_PART_PIN cannot be assigned to more than one port [design_1_PmodAD1_0_0_board.xdc:7]
Is there a Nexys 4 DDR/Vivado 2016.4 specific library I need? Or is there an easy way to upgrade the IP?
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.