Jim Kirk Posted June 1, 2017 Share Posted June 1, 2017 Hi all, The Waveforms program installed on my 64bit, Win 10 Laptop fails to connect correctly to the Digilent devices. I have tested with an Analog Discovery 2 and Analog Discovery, both were tested in other PC's so there is no external hardware issue. As shown in the attachment, Waveforms is reading the S/N from the device and current draw is within the expected range. My best guess is that there is a USB driver issue, what are your thoughts? Link to comment Share on other sites More sharing options...
jpeyron Posted June 1, 2017 Share Posted June 1, 2017 Hi @Jim Kirk, To make sure we are on the same page, you are able to get an AD2 and AD1 to work on other laptops but you get the Waveform error in the screen shot attached when you try to use either the AD2 or AD1 on your computer.. I believe what the erc code and the configuration failed(PLL3) says is that the device does not get enough power. Too much is consume after the device clocking is started. You could try using a powered USB hub. @attila could you confirm this. cheers, Jon Link to comment Share on other sites More sharing options...
attila Posted June 2, 2017 Share Posted June 2, 2017 Hi @Jim Kirk Try using another USB cable, laptop plug, powered USB hub or 5V DC supply for AD2. Link to comment Share on other sites More sharing options...
Question
Jim Kirk
Hi all,
The Waveforms program installed on my 64bit, Win 10 Laptop fails to connect correctly to the Digilent devices.
I have tested with an Analog Discovery 2 and Analog Discovery, both were tested in other PC's so there is no external hardware issue.
As shown in the attachment, Waveforms is reading the S/N from the device and current draw is within the expected range.
My best guess is that there is a USB driver issue, what are your thoughts?
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.