as far as I am aware, it is not possible to transmit or receive any messages over CAN with the ArtyZ7-Board. Are there any extensions for the board to make that possible? At first, I want that the Zynq will address each led according to the received message - just the beginner stuff :-). Addition to that, I want to create a communication between the Zynq and a microcontroller over CAN, so I can create a "tiny" Master-Slave-System.
Question
embeddedT
Hi,
as far as I am aware, it is not possible to transmit or receive any messages over CAN with the ArtyZ7-Board. Are there any extensions for the board to make that possible? At first, I want that the Zynq will address each led according to the received message - just the beginner stuff :-). Addition to that, I want to create a communication between the Zynq and a microcontroller over CAN, so I can create a "tiny" Master-Slave-System.
Best regards from Germany,
Thomas
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.