I am using an ARTY board. I have just used the constraints as is without making any changes. I do not see any constraints for drive strength or Slew rate attribute anywhere in the XDC file. I am wondering how it is determined that the default values are sufficient for these attributes. For example for the Ethernet PHY i browsed thru the datasheet but didnt see anything that would make it clear to select 12mA (default) drive strength for those pins.
Question
db12321
I am using an ARTY board. I have just used the constraints as is without making any changes. I do not see any constraints for drive strength or Slew rate attribute anywhere in the XDC file. I am wondering how it is determined that the default values are sufficient for these attributes. For example for the Ethernet PHY i browsed thru the datasheet but didnt see anything that would make it clear to select 12mA (default) drive strength for those pins.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.