Adept does not recognize cpld xc2c2 "initialization failed check connection try again"
Shows current and signal the problem is that when running the adept program

Share this post

Link to post
Share on other sites

1 answer to this question

Recommended Posts

  • 0

Hi @Burth,

Welcome to the forums! What OS are you running? If you are in Linux, were you root when you installed Runtime and Adept?  Is this the Coolrunner II? If so, you need to make sure to have the JP2 set to reg as shown on the attached picture. If i did not have JP2 jumpered correctly Adept did not see the CPLD XC2C2 as shown below and like you are describing. If this is not the case change out the cable you are using.






Edited by jpeyron

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now