I have a Genesys board with Virtex 5 FPGA on it. I have problems configuring the flash ROM and I need help, please.
Just to mention that configuring the FPGA straight is successfully done, but I would like to operate it from the flash.
The operation for flash configuration starts correctly. I mean, I can erase the flash and I see on the display the message "Erasing Flash Passed". When I start programming the flash (using 007-Genesys-1.bit file) on the computer everything looks OK. I see:
"Configuring with memory manager..
Flash configuration successful.
Toggle board power to load from flash"
Meantime on the display, I see:
"Entering Send Mode"
and then only "S_"
Switching the power after that, has no effect. I tried in both cases BPI UP or BPI DOWN, corresponding with the screen indication, but no difference.
I missed something in the procedure ? Can I check something else on the board?
Question
andreid
Hi,
I have a Genesys board with Virtex 5 FPGA on it. I have problems configuring the flash ROM and I need help, please.
Just to mention that configuring the FPGA straight is successfully done, but I would like to operate it from the flash.
The operation for flash configuration starts correctly. I mean, I can erase the flash and I see on the display the message "Erasing Flash Passed". When I start programming the flash (using 007-Genesys-1.bit file) on the computer everything looks OK. I see:
"Configuring with memory manager..
Flash configuration successful.
Toggle board power to load from flash"
Meantime on the display, I see:
"Entering Send Mode"
and then only "S_"
Switching the power after that, has no effect. I tried in both cases BPI UP or BPI DOWN, corresponding with the screen indication, but no difference.
I missed something in the procedure ? Can I check something else on the board?
Thank you very much for help,
andreid
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.