DS2 alert and loss communication. DPti IO Failed :0xA
Using the logic analyzer attached to a chip with max voltage of 5vdc
I connect the ground DS2 to the ground on the chip and a few of the inputs to the other pins that will be high 5 volts or Low 0 volts.
The chip is on an inverter. The DS2 displays logic readings fine until I turn the inverter on and then I get the alert and the DS2 looses connection. I have to shutdown the inverter and disconnect and reconnect the USB cable to get communication back.
Question
Dcormier
DS2 alert and loss communication. DPti IO Failed :0xA
Using the logic analyzer attached to a chip with max voltage of 5vdc
I connect the ground DS2 to the ground on the chip and a few of the inputs to the other pins that will be high 5 volts or Low 0 volts.
The chip is on an inverter. The DS2 displays logic readings fine until I turn the inverter on and then I get the alert and the DS2 looses connection. I have to shutdown the inverter and disconnect and reconnect the USB cable to get communication back.
Any help appreciated.
Thanks
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.