I recently purchased the pmodbt2 bluetooth interface module and tried interfacing it with the Atlys board. I used the GPIO demo bit file which was given in the forum for verification (after modifying it), but I was not able to see the output in the terminal software (Teraterm). I followed the instructions given in the demo, but I was not able to see the output; are there any specific changes I need to make in the module or in the terminal software?
Question
ishan
Hi,
I recently purchased the pmodbt2 bluetooth interface module and tried interfacing it with the Atlys board. I used the GPIO demo bit file which was given in the forum for verification (after modifying it), but I was not able to see the output in the terminal software (Teraterm). I followed the instructions given in the demo, but I was not able to see the output; are there any specific changes I need to make in the module or in the terminal software?
Can someone help me out with this?
Ishan
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.