I programmed my flash recently, but the sdk .elf file didn't seem to be working so I attempted the whole process again. However, now my board seems to be stuck in somewhere not so good. When I plug the USB in, only a red led is on, compared to originally before flash, the orange done led was also on. Also, now I can no longer program the qspi flash in vivado hardware manager anymore. It always fails during the programming stage because the blank check fails. Is my flash stuck in some kind of mode? Also, how can I clear it and restore my fpga to it's original state? Thanks!
Question
vc26
Hi all,
I programmed my flash recently, but the sdk .elf file didn't seem to be working so I attempted the whole process again. However, now my board seems to be stuck in somewhere not so good. When I plug the USB in, only a red led is on, compared to originally before flash, the orange done led was also on. Also, now I can no longer program the qspi flash in vivado hardware manager anymore. It always fails during the programming stage because the blank check fails. Is my flash stuck in some kind of mode? Also, how can I clear it and restore my fpga to it's original state? Thanks!
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.