I have been making progress with the Zynq tutorials on Zedboard and currently stuck at the LED_controller_test_tut_4A which is about designing Zynq IP in HDL.
I went through the steps and am able to run the SW application. The console shows me the LED values output but the LEDs are not flashing(not driven).
Is this a known issue with the tutorial files.
I am using Vivado, SDK 2015.4
LED value: 19
LED value: 20
LED value: 21
LED value: 22
LED value: 23
LED value: 24
LED value: 25
LED value: 26
LED value: 27
LED value: 28
LED value: 29
LED value: 30
LED value: 31
Appreciate your experience or clues before I dig deep.
Question
egnanam
Hi,
I have been making progress with the Zynq tutorials on Zedboard and currently stuck at the LED_controller_test_tut_4A which is about designing Zynq IP in HDL.
I went through the steps and am able to run the SW application. The console shows me the LED values output but the LEDs are not flashing(not driven).
Is this a known issue with the tutorial files.
I am using Vivado, SDK 2015.4
LED value: 19
LED value: 20
LED value: 21
LED value: 22
LED value: 23
LED value: 24
LED value: 25
LED value: 26
LED value: 27
LED value: 28
LED value: 29
LED value: 30
LED value: 31
Appreciate your experience or clues before I dig deep.
Regards,
Gnanam
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.