We are looking to use the Arty board for first tests on a machine vision system we are developing, which runs a 72 MHz parallel interface.
For ease of testing I was planning to use the Arty board and its I/Os, but I see that it has 200 Ohm series resistors on each pin which will put a limit on the max allowed switching speed.
Are there any specifications on the pins when it comes to speed? With 200 Ohms about 5-8 pF is maximum allowed after the resistor for a 72 MHz signal.
Else, as I do not have the board yet, are the resistors easy to get to (silkscreen designators for correct identification) to replace the resistors manually with a lower value?
Question
Korken
Hi all,
We are looking to use the Arty board for first tests on a machine vision system we are developing, which runs a 72 MHz parallel interface.
For ease of testing I was planning to use the Arty board and its I/Os, but I see that it has 200 Ohm series resistors on each pin which will put a limit on the max allowed switching speed.
Are there any specifications on the pins when it comes to speed? With 200 Ohms about 5-8 pF is maximum allowed after the resistor for a 72 MHz signal.
Else, as I do not have the board yet, are the resistors easy to get to (silkscreen designators for correct identification) to replace the resistors manually with a lower value?
Thank you for your time!
Link to comment
Share on other sites
10 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.