Jump to content
  • 0

JTAG SMT1 vs. SMT2


imaviet

Question

Hello,

 

I am looking to replace the JTAG SMT1 programming module on a VC701 evaluation board with a Virtex 7 FPGA due to a bad micro USB connector. The JTAG SMT1 module is not in stock anymore, and I was wondering if JTAG SMT2 would be compatible with the eval board I am using. The difference between the two modules are SMT2 has GPIO. The rest of the JTAG port connections are identical. Since I will not be using the GPIO, is it ok to leave these pins floating? Thank you for your help.

 

 

VC701

http://www.xilinx.com/support/documentation/boards_and_kits/vc709/ug887-vc709-eval-board-v7-fpga.pdf

 

JTAG SMT1 Module

https://www.digilentinc.com/Products/Detail.cfm?NavPath=2,395,923&Prod=JTAG-SMT1

 

JTAG SMT2 Module

https://www.digilentinc.com/Products/Detail.cfm?NavPath=2,395,1053&Prod=JTAG-SMT2

Link to comment
Share on other sites

4 answers to this question

Recommended Posts

The USB connector is not something that can be sourced through typical online channels (digikey, etc.). I've asked for a datasheet so that you can try to source an equivalent one. When I get it I'll post it here.

Edit: FYI, if the traces got ripped off with the USB connector it is not likely you will be successful replacing the connector alone. In that case you will likely need another SMT module. 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...