Hamzeh Posted February 5, 2017 Share Posted February 5, 2017 In widows 7 can not drive usb.i want program spartan with usb cable.please help my.tanks Link to comment Share on other sites More sharing options...
jpeyron Posted February 6, 2017 Share Posted February 6, 2017 Hi Hamzeh, You should be able to use Adept 2 to program you bit file to the Nexys 2. Here is a link to the software. Are you using ISE 14.7 to generate the bit file? cheers, Jon Link to comment Share on other sites More sharing options...
Hamzeh Posted February 6, 2017 Author Share Posted February 6, 2017 hi yes dear i use adept2 v2.16 .my Windows was not known the nexys2 board when plug usb cable to pc. I can't program fpga. Link to comment Share on other sites More sharing options...
jpeyron Posted February 6, 2017 Share Posted February 6, 2017 Hi Hamzeh, When you go into the device manager are you able to see a digilent device is connected under usb? Could you take screen shots of what you see. Have you tried using a different cable. Not all USB A to Micro-B cables have the data line attached, some just have the power connected in the cable. cheers, Jon Link to comment Share on other sites More sharing options...
Hamzeh Posted February 8, 2017 Author Share Posted February 8, 2017 hi dear when connected to pc in device managaer show unknown device . i using 3 a different cable but not result. Should I install drivers CY7C68013A usb ic? dear do you have a telegram ? if posible send pm +989336480076 . tnx alot Link to comment Share on other sites More sharing options...
jpeyron Posted February 8, 2017 Share Posted February 8, 2017 Hi Hamzed, You can pm me in the forum or email at jpeyron@hotmail.com of jon.peyron@digilent.com I would uninstall and then re-install adept 2, reboot computer and then try connecting. cheers, Jon Link to comment Share on other sites More sharing options...
Hamzeh Posted February 9, 2017 Author Share Posted February 9, 2017 Hi dear If posible you instal adept2 and screen shot step by step.tnx alot dear Link to comment Share on other sites More sharing options...
jpeyron Posted February 9, 2017 Share Posted February 9, 2017 Hi Hamzeh, Here is a step by step wiki with pictures on how to remove programs in Window's 7. After you have removed Adept 2 re-install it and reboot the computer. At this point re-try to connect the Nexys 2 using the Adept software. cheers, Jon Link to comment Share on other sites More sharing options...
Question
Hamzeh
In widows 7 can not drive usb.i want program spartan with usb cable.please help my.tanks
Link to comment
Share on other sites
7 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.