Am trying to load uboot(Xilinx) and bring the Zynq zc702 board up from sdcard. When i tried to connect to the board through the picocom command am able to enter till terminal ready after that i have not seen any logs related to uboot and the terminal is getting stuck and searched over the internet for the solution but still am not sure why it's happening like this. Please can i get some info on this
please can some one show me the connections of bringing up the board using digilent J-TAG cable because when i give the command "connect arm hw" am getting cable error in XMD console
Question
lakshmis
Am trying to load uboot(Xilinx) and bring the Zynq zc702 board up from sdcard. When i tried to connect to the board through the picocom command am able to enter till terminal ready after that i have not seen any logs related to uboot and the terminal is getting stuck and searched over the internet for the solution but still am not sure why it's happening like this. Please can i get some info on this
please can some one show me the connections of bringing up the board using digilent J-TAG cable because when i give the command "connect arm hw" am getting cable error in XMD console
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.