Just got my Zybo board and tested it with this tutorial. Everything went perfectly well, beside the 2nd part of the last step - didnt get any messagees when pressing the buttons.(I enabled the STDIO via the debug configurations, see attached snapshot)
11.4) The demo will be running on the ZYBO. Try playing around with the 4 switches. Doing so should light its respectiveLED. Also over the serial port, each button press will produce the message “button x pressed”
Question
altus
Hi,
Just got my Zybo board and tested it with this tutorial. Everything went perfectly well, beside the 2nd part of the last step - didnt get any messagees when pressing the buttons.(I enabled the STDIO via the debug configurations, see attached snapshot)
11.4) The demo will be running on the ZYBO. Try playing around with the 4 switches. Doing so should light its respective LED. Also over the serial port, each button press will produce the message “button x pressed”
Thanks
Udi
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.