nima Posted September 12, 2016 Share Posted September 12, 2016 Hi I am a new user, just trying to setup the digilent Atlys board, in Windows 10 with ISE 14.5 I have installed the UART driver "XR21V1410" from EXAR. But Adept 2 doesn't detect the board at all. (No device connected) I am using the programing UART port with a USB cable for connecting the board to pc. Thanks for your help in advance Link to comment Share on other sites More sharing options...
JColvin Posted September 12, 2016 Share Posted September 12, 2016 Hi Nima, I have moved your question to the FPGA section of the forum where the engineer best suited to help you will be able to see and respond to your question. I have also asked some of our applications engineers for further input on this. Thanks, JColvin Link to comment Share on other sites More sharing options...
jpeyron Posted September 12, 2016 Share Posted September 12, 2016 Hi Nima, I don't have a windows 10 device to test it on, on windows 8.1 i was able to get adept 2 to reconize the the digilent Atlys board. I also was able to get our gpio demo to run on ise 14.7 as well. I have attached some pictures of Adept 2 and how I have the Atlys set up. You would not need the HDMI in or out connected. In the device manager, can you see the digilent usb device for the programer connection? The uart connection will show up under ports. Both the programmer and uart connect is shown in the picture below. Please attach a screen shot of the Adept 2 when the Atlys is connected and turned on. cheers, Jon Link to comment Share on other sites More sharing options...
nima Posted September 13, 2016 Author Share Posted September 13, 2016 Hello Jon Thanks for the information you posted. The problem was actually with my USB cable! I usually use this cable for charging my phone, seems to be fine. But for some reason, it didn't make a proper connection with the input port on the board. Adept is detecting the board now Thanks Nima Link to comment Share on other sites More sharing options...
Question
nima
Hi
I am a new user, just trying to setup the digilent Atlys board, in Windows 10 with ISE 14.5
I have installed the UART driver "XR21V1410" from EXAR. But Adept 2 doesn't detect the board at all. (No device connected)
I am using the programing UART port with a USB cable for connecting the board to pc.
Thanks for your help in advance
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.