JColvin Posted August 24, 2016 Share Posted August 24, 2016 A customer on our website asked the following question: Hi,I would like to reset(clear program) on netfpga 1g cml to go to original factory setting.How to do please suggest me.regard, The response is below. Link to comment Share on other sites More sharing options...
JColvin Posted August 24, 2016 Author Share Posted August 24, 2016 Hello, If you have not modified the flash on the board, you should be able to disconnect it from power and then re-connect it to remove any program that was on the FPGA. I will ask some of our applications engineers to see if there is any design shipped with the board; they will get back to you here on the Forum. Thanks, JColvin Link to comment Share on other sites More sharing options...
Bianca Posted August 25, 2016 Share Posted August 25, 2016 Hello, We do not have any design since the support for the NetFPGA-1G-CML is done by the NetFPGA community, You need to access the NetFPGA forum. If you are not already registered, you can use the registration link located on the “Getting Starded” page here. Once registered, you should use the NetFPGA forum to post your question. It is an active forum and they will help you with your problem. Best regards, Bianca Link to comment Share on other sites More sharing options...
Question
JColvin
A customer on our website asked the following question:
Hi,
I would like to reset(clear program) on netfpga 1g cml to go to original factory setting.
How to do please suggest me.
regard,
The response is below.
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.