Jump to content
  • 0

Zybo board 1.8V logic


malkauns

Question

I have a quick question.  I am trying to interface my Zybo board with a camera module (Arducam OV5640).  The datasheet says that it uses 1.8/2.8V logic.  In my XDC file do I simply use IOSTANDARD LVCMOS18 for each pin?  I have tried this using the pmod connectors on the Zybo board and setting one pin high but when I check the voltage with a multimeter it reads 3.3V.

Link to comment
Share on other sites

3 answers to this question

Recommended Posts

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...