• 0
Sign in to follow this  
prince

configuring basys3 with qspi flash fails

Question

Hi,

I am trying to program basys3 from qspi flash. I have made a microblaze based system with qspi flash (BD attached) in vivado. I have tried the tutorial in this link below to make a qspi srec bootloader to put my application in flash. I have used FLASH_IMAGE_BASEADDR   in blconfig.h as 0x47200000 (XPAR_AXI_QUAD_SPI_0_BASEADDR = 0x46000000 + offset = 0x01200000). However, I cannot program the flash for this address offset. The program fails with the error as  "ERROR: [Xicom 50-47] Start address (0x01200000) is outside of the device memory range." However, if i try with small offset (0x00c0000) I can successfully program the flash but I don't get any output in terminal

http://www.xilinx.com/support/answers/64238.html

any help appreciated.

thanks in advance,

 

Capture.PNG

Capture1.PNG

Share this post


Link to post
Share on other sites

3 answers to this question

Recommended Posts

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this