I newly have the ARTY 100 FPGA PCB and am advised by the Synthesis Tool to setup two values for the bank 1 / config. Any idea what to set there? Is it 3.3V and VCC?
For the moment I do not set anything at all there, thay with the warnings but have a running board. (almost at least- see the other thread)
Question
engi
I newly have the ARTY 100 FPGA PCB and am advised by the Synthesis Tool to setup two values for the bank 1 / config. Any idea what to set there? Is it 3.3V and VCC?
For the moment I do not set anything at all there, thay with the warnings but have a running board. (almost at least- see the other thread)
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now