Jump to content

Manipulate PL logic using PS registers


zygot

Recommended Posts

Think that you need AXI busses or complicated logic design to use the PL in your fancy ZYNQ device? Well, this demo proves that you don't. Find out how to read and write registers in your PL logic design just by reading and writing a few registers in the PS register set.

By routing an unused PS UART to the PL via EMIO you can have a full-duplex data path as well as 6 additional input or output signals. What could be easier?

EmioUartDemo_R1.zip

Edited by zygot
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...