• 0

Zynq 7020 : IOB warning [Place 30-722]


Question

[Place 30-722] Terminal 'adc_dat_i[0]' has IOB constraint set to TRUE, but it is either not connected to a FLOP element or the connected FLOP element could not be brought into the I/O

While working with FPGA , after implementation, this critical warning is been shown

How can I overcome this

I am trying to connect xadc of Zynq 7020 to my design.

I have attached my design,warning messages and xdc file screenshots.

image.thumb.png.0a96a25ed2bb9286d74dae9ec9b22c46.png

 

image.png.4e7e5407e15d5830e7a8121b65837ab6.pngimage.thumb.png.5e358cbc0484411bb5ca0be37b2986a9.png

Link to post
Share on other sites

1 answer to this question

Recommended Posts

  • 0

Hi @msamirh

You will need to use the XADC wizard IP to configure the XADC and get an interface to pull data from it - likely a DRP interface if you don't want to use the Zynq PS. For a starting point to see how this works, I'd recommend checking out the Zybo Z7's xadc demo: https://digilent.com/reference/programmable-logic/zybo-z7/demos/xadc

Thanks,

Arthur

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now