I am using the Zybo board with vivado 2014.1. So, while creating project, i have chosen the corresponding part.
Since i have chosen the part rather than the board, i have to change the input frequency value in the clock configuration tab of PS customization to 50 MHz.
I wanted to use the UART on Zybo board. I have customized my PS keeping only the UART1 port.
The thing is data sending on uart (from board to pc) is working fine. I have done this by reading the status of the DIP
switches on the board. But, when i am trying to read values from Pc to the board (key entered on the keyboard), the output is not as expected.
Question
gayathri90
Hi...
I am using the Zybo board with vivado 2014.1. So, while creating project, i have chosen the corresponding part.
Since i have chosen the part rather than the board, i have to change the input frequency value in the clock configuration tab of PS customization to 50 MHz.
I wanted to use the UART on Zybo board. I have customized my PS keeping only the UART1 port.
The thing is data sending on uart (from board to pc) is working fine. I have done this by reading the status of the DIP
switches on the board. But, when i am trying to read values from Pc to the board (key entered on the keyboard), the output is not as expected.
Can anybody put in some suggestions??
Thanks in advance
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.