JTAG-HS2 problems in Linux

[sthornington 1]

Hi folks - I just bought a JTAG-HS2 cable to try to program and debug my Numato Mimas A7 from Vivado.  Vivado detects the cable and the FPGA beyond it, but when I try to program, it gives me an error (attached).  

Okay, so I went back to basics, and tried to check out the chain using openocd, but openocd can't even find the cable at all!  (attached)

Am I missing something obvious here?  

 

[sthornington 1]

Following some other threads to their root cause, I decided to try using USB power on the Numato Mimas A7 by changing the jumper P2 from EXT (I had connected a 12V 2A supply) to USB (the USB-B cable also attached to my host.  It worked after this.  Thanks.

[sthornington 1]

I'm still not certain why openocd does not open the device, but this I am less concerned about, since the entire reason for me to get this JTAG-HS2 was to be able to use the ILA in my designs which use the Vivado block diagram designer.   I will figure that out later!