I am using a Chip having Synopsys EM4 core, To debug this I am using the JTAG-USB (JTAG-USB Cable) to connect to the target.
I am continuously getting this message on IDE or Synopsys MDB
Debugger log
[JTAG] JTAG failed after 10 attempts; attempted operation was memory_read/1.
[JTAG] (JTAG status register is 0x6 = :failed:ready.)
[JTAG] Memory read at 0x10000000 for 0x4 bytes failed (busy).
[JTAG] Last JTAG status register = 0x6 = :failed:ready.
[JTAG] JTAG failed after 10 attempts; attempted operation was memory_read/1.
[JTAG] (JTAG status register is 0x6 = :failed:ready.)
Console Window Output
I have verified I am using the correct TCF file which is sent by chip manufacturer
Question
Deepak Joshi
Hello,
I am using a Chip having Synopsys EM4 core, To debug this I am using the JTAG-USB (JTAG-USB Cable) to connect to the target.
I am continuously getting this message on IDE or Synopsys MDB
Debugger log
[JTAG] JTAG failed after 10 attempts; attempted operation was memory_read/1.
[JTAG] (JTAG status register is 0x6 = :failed:ready.)
[JTAG] Memory read at 0x10000000 for 0x4 bytes failed (busy).
[JTAG] Last JTAG status register = 0x6 = :failed:ready.
[JTAG] JTAG failed after 10 attempts; attempted operation was memory_read/1.
[JTAG] (JTAG status register is 0x6 = :failed:ready.)
Console Window Output
I have verified I am using the correct TCF file which is sent by chip manufacturer
By debugger settings are below
-toggle=include_local_symbols=1 -profile -prop=dig_speed=10000000 -digilent
Thanks in advance
Best Regards,
Deepak Joshi
Link to comment
Share on other sites
3 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.