I am trying to interface my digilent openlogger MZ via serial communication in hopes to send parameters to the oscilloscope and read the data back. At first on Putty when I entered the serial port and the baud rate (com11/9600 baud) all it gave me was a black black screen. FYI, I also tried with all the applicable baud rates but was no success.
However, after reading some articles with previous projects I pressed the reset button and this time it gave some information about the openlogger as follows:
So based on what I received I suppose the openlogger has successfully connected but it says "Failed to Autoconnect,error:A000001B". Please provide assistance. Thanks!
Question
Pietro
Hi there,
I am trying to interface my digilent openlogger MZ via serial communication in hopes to send parameters to the oscilloscope and read the data back. At first on Putty when I entered the serial port and the baud rate (com11/9600 baud) all it gave me was a black black screen. FYI, I also tried with all the applicable baud rates but was no success.
However, after reading some articles with previous projects I pressed the reset button and this time it gave some information about the openlogger as follows:
So based on what I received I suppose the openlogger has successfully connected but it says "Failed to Autoconnect,error:A000001B". Please provide assistance. Thanks!
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.