My Basys3 board is not recognized in Vivado. I installed Vivido v2020.2 with little effort (although it took well over an hour). When I connect the USB cable and turn the power on nothing happens inside of Vivido. My board is jumpered for JTAG using JP1 (center pins). If I view the hardware manager it shows "unconnected No hardware target open". Clicking Open target than auto-connect shows no change. Only localhost (0) connected is listed. In Windows10 device manager, I do see 2 USB entries labeled "Digilent USB Device" with a value of, Dual RS232-HS (interface 0) and Dual RS232-HS (interface 1). I have power cycled my computer but no change. I can successfully copy the Project.BIT file to a USB drive and load the board that way after changing the jump. What do I try next to establish JTAG connection?
Question
Bryan2
My Basys3 board is not recognized in Vivado. I installed Vivido v2020.2 with little effort (although it took well over an hour). When I connect the USB cable and turn the power on nothing happens inside of Vivido. My board is jumpered for JTAG using JP1 (center pins). If I view the hardware manager it shows "unconnected No hardware target open". Clicking Open target than auto-connect shows no change. Only localhost (0) connected is listed. In Windows10 device manager, I do see 2 USB entries labeled "Digilent USB Device" with a value of, Dual RS232-HS (interface 0) and Dual RS232-HS (interface 1). I have power cycled my computer but no change. I can successfully copy the Project.BIT file to a USB drive and load the board that way after changing the jump. What do I try next to establish JTAG connection?
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.