I am currently working with a ArtyZ7 Board and wanted to create an Interface to a new IMU-Chip from Invensense. I checked the Board Voltage therefore: It was 3.65V instead of 3.3V. To set down this voltage I see I have to replace the R259 or R261 resistor. Unfortunately I can nowhere see, where exactly this resistor is placed. Are there no Layouts available? Even in the 3d Model there are no resistors. I thought maybe I can get the location there.
Question
metty
I am currently working with a ArtyZ7 Board and wanted to create an Interface to a new IMU-Chip from Invensense. I checked the Board Voltage therefore: It was 3.65V instead of 3.3V. To set down this voltage I see I have to replace the R259 or R261 resistor. Unfortunately I can nowhere see, where exactly this resistor is placed. Are there no Layouts available? Even in the 3d Model there are no resistors. I thought maybe I can get the location there.
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.