mjacome 0 Posted November 18, 2020 Share Posted November 18, 2020 Hello, I see in the manual that the WG has + and - supplies, though the supplies are limited to 5V. Is it possible to use both WG outputs in sync to do a ramp from -5 to +5V? I want to do a 0-10V sweep. Link to post Share on other sites
0 attila 498 Posted November 19, 2020 Share Posted November 19, 2020 (edited) Hi @mjacome You could use V- or W2 at -5V as virtual ground for your circuit and generate with W1 ramp from -5V to 5V. This relative to -5V would be 0 to 10V. Note the W1/2 can drive up to 10-50mA ! Here Scope 1- (negative input) is connected to W1 W2 -5V Generating ramp up and down differentially is -10 to +10V Edited November 24, 2020 by attila mjacome 1 Link to post Share on other sites
0 mjacome 0 Posted November 20, 2020 Author Share Posted November 20, 2020 Thank you! To achieve these results I had to connect scope 1- (negative input) to W2 AND scope 1+ (positive input) to W1. Link to post Share on other sites
0 attila 498 Posted November 24, 2020 Share Posted November 24, 2020 Hi @mjacome Yes. I wanted to say in the above example 1- to W2 and 1+ to W1. Link to post Share on other sites
Question
mjacome 0
Hello,
I see in the manual that the WG has + and - supplies, though the supplies are limited to 5V.
Is it possible to use both WG outputs in sync to do a ramp from -5 to +5V? I want to do a 0-10V sweep.
Link to post
Share on other sites
3 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now